Презентация Profile leveling онлайн

Содержание слайда: Earthwork Profile Leveling

Содержание слайда: Profile Leveling To collect data about topography along a reference line. Mainly to compute volumes of cut and fill for a proposed linear structure, such as: highways, railroads, transmission lines, canals. Then the best route can be chosen. The result: elevations at definite points (stations) along a reference line, usually the center line.

Содержание слайда: Staking and Stationing the Reference Line First, topography is studied, a center line is chosen. Second, points (stations) are marked (staked). Stations are set at starting and ending points, then intermediate stations. Distance between the intermediate stations is usually 100ft, could be less if topography is rough. Stationing: a system adopted to specify the relative positions of points along the reference line. Distances are written in the form of a sum: A + B. A is hundreds of feet, B is feet.

Содержание слайда: For example station K is (10+24.5) = 1024.5ft from a certain zero, may not exist. For example station K is (10+24.5) = 1024.5ft from a certain zero, may not exist. First station is usually designated with arbitrary value: 10+00, 100+00 To compute distances along the line, erase the + sign, and subtract the two numbers Distance between the stations:(20+68) and (30+34) = 3034 - 2068 = 966 ft

Содержание слайда: First a backsight at a BM is observed. First a backsight at a BM is observed. Then, a number of intermediate foresights are observed at the stations needed, do not have to be at equal distances. When the distance becomes too long, or readings become hard to observe, a turning point is constructed. You cannot keep the backsight distance equal to the foresight distance.

Содержание слайда: Figure 5.11 Profile leveling.

Содержание слайда: Elevation computation: Elevation computation: Elevation of line of sight (LS) = EBM + BSBM. Elevation of any intermediate point = ELS - FSIP. Handle new level positions as in differential leveling, construct a turning point and knowing BS and FS readings, compute a new elevation of line of sight. See figure (5-12) page 119 for example of field data and adjustment.

Содержание слайда:

Содержание слайда:

Содержание слайда:

Содержание слайда:

Содержание слайда: Drawing and Using Profiles Drawn using a software now.The following is for reference only, will not be in exams. To manually draw a profile and compute earthwork: {the following is for reference only, will not be included in exams} Assume the horizontal axis is the distance and the vertical axis is the elevation. Use a larger scale for the elevation than the distance scale, usually 10 times larger. Draw the design line at the proposed grade. Compute the areas of cut and fill. Multiply area by width to get volumes. Gradient (percent grade) is the rise or fall in ft per 100 ft, or meter per 100 meter.

Содержание слайда: Figure 5.13 Plot of profile.